Cutlass bearing on 190
Just had a bit of a fiddle with the prop after taking the boat out and there is a bit of up and down movement in the shaft I am making the assumption its the cutlass bearing so I think it will have...
View ArticleRe: Cutlass bearing on 190
Dead easy ron you will find to plastic screwa either side of housing undo remove prop managed to wangle old bearing out push up new bearing re fit screws if screws need repacing go to halfords they do...
View ArticleRe: Cutlass bearing on 190
Ron the hardest bit is getting the prop off, if your prop gives itself up easythen thats 90% of the job done, i made up a prop puller from a post on thissite and it works a treat,Michael
View ArticleRe: Cutlass bearing on 190
Hi Ron , as micheal says once prop off simple task, I have the cutless bearing in stock and they come with replacement nylon screws too !! give me a shout if you would like one 07786063770 Stu
View ArticleRe: Cutlass bearing on 190
Thanks for the chat Stu, whole job took about an hour and a half. prop came off with the help of a wooden mallet , had to drill one plastic screw out thats all. Ron
View ArticleClik here to view.
Re: Cutlass bearing on 190
Hi Ron glad your sorted all part of the service !!! thanks for your orderStuart
View ArticleRe: Cutlass bearing on 190
Hi Stuart, I will need a new cutlass bearing shortly. The guy(approved marina contractor) who will be doing the work insists that he obtain the parts, fortunately he doesn't add to the costs from a s a...
View ArticleRe: Cutlass bearing on 190
Hi Barry , assume your cutless only needs changing due to north and south excess movement ? If its only the cutless to be changed there is no need to remove shaft from gearbox to do it ( all done from...
View ArticleRe: Cutlass bearing on 190
Hi Stu, I've been off for a while hence delay in responding. Last time out I tried to give it a blast to keep the turbo clean but I had to back off due to a vibration above 2000 rpm. Prop definitely...
View ArticleRe: Cutlass bearing on 190
Hi Barry ,Give me a shout i can get your cutless sleeve no problem! Don't remember the nuts of flanges being too large or silly tight but do remember the hex bolts on the shaft being VVVVVEEERRYY...
View ArticleRe: Cutlass bearing on 190
A good soaking in WD40 the day before you start the works helps Michael
View ArticleRe: Cutlass bearing on 190
Trust me Mickey knows he did mine !!! Good soaking , strong tools the way to go !! Stu
View ArticleRe: Cutlass bearing on 190
Hi Folks,Thanks for your input. I have split the halve coupling, gearbox to shaft, bolts were very tight and access is not brilliant. The mis alignment is about 9 thou, that is a 9 thou feeler will fit...
View Article